Hi,
I have a question about the rule logic display when a section is applied. In the report view, I can see the rule logic/implementation when I select a rule. However, once I select a section and do the same, I can only see the valid and invalid results, not the rule logic. Is there a reason behind it?
Thank you!
Best answer by srija piratla
Hi
The left side displays the rules applied to the catalog item, while detailed results for the rule logic, including valid and invalid outcomes, can be accessed by clicking on the DQ checks. The reason for the if you click it gives the complete logic and but we cannot get the logic under this arrow.
Hope this helps !
Regards,
Srija Piratla
Hi
I see that you are trying to see under the section but this how it is implemented to make sure it is user friendly and for example if there is a complex logic and it is hard to understand the invalid results under section.
This is more easier to check the logic and how many records failed here. Hope this helps.
Regards,
Srija Piratla
Hi Srija! Thanks for answering but Im not sure if I understand the reason, since its very easy to select the āString Completenessā when a catalog item is selected, like the picture below.
But I am not able select āString Completenessā (the red arrow) like in this picture if a section is selected?
Hi
The left side displays the rules applied to the catalog item, while detailed results for the rule logic, including valid and invalid outcomes, can be accessed by clicking on the DQ checks. The reason for the if you click it gives the complete logic and but we cannot get the logic under this arrow.
Hope this helps !
Regards,
Srija Piratla
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
